Allpro ScanX-12 DVM Wartungshandbuch

Instruction ManualPart Numbers: B8100

10IMPORTANT: To operate the ScanX, it must be connected to a compliant Computer System, and the computer must be loaded with an authorized Imaging Sof

11COMPUTER SYSTEM REQUIREMENTSCONTROLS AND INDICATORSALLPROIMAGINGREADY ERASERFLASHINGOFFALLPROIMAGINGREADY ERASERFLASHINGOFFREADY SwitchFLASHING OFF

12TECHNICAL DATAElectrical Requirements:Supply Voltage: 100 to 240VAC +/- 10%, 50/60 Hz Supply Current: 2A MaximumLine Cord: Country Specific Hospi

13The ScanX is a completely portable system that can be located anywhere a grounded electric Mains AC outlet and a compliant lapto

14SYSTEM SETUPNote: Authorized Imaging Software supplied by the dealer or other company, must be installed on the computer in order to ope

15Figure 2. Typical ScanX InstallationSYSTEM SETUP4 Scanner TrackIndicator LEDsNote:The Switch is the Mains dis-connect device.Press HERE toturn

16Prior to performing the imaging procedure provided on the following pages, the user must be familiar with the care, handling and preparation of the

17PLATE CARE & PREPARATIONIMPORTANT: PSPs must always be erased prior to use.Note: Use PSPs within 24 hours of last erasure. Repeat erasing proc

18IMAGING PROCEDURES1. Orient the cassette so that the Tube side is facing down and the hinge is away from you. 2. Open the cassette and gra

19IMAGING PROCEDURESScanning and Erasing Plates (continued)5. At this point, all four track lights will turn yellow, indicating the PSP has been sens

TABLE OF CONTENTS2FOREWORDAir Techniques and its ALLPRO Imaging division have prepared this document as a guide to the proper use of the ScanX® 12 Po

20MAINTENANCE Maintenance ProceduresThe ScanX is designed for many years of trouble-free operation. Maintenance as described herein is minimal.IMPORTA

21TROUBLESHOOTINGTrouble Possible Cause Corrective Action1. No power/No green light on membrane switch• Not plugged in.• No power at Mains Outlet•

22TROUBLESHOOTINGTrouble Possible Cause Corrective Action6. Image is too dark. • PSP has been overexposed • Use software to adjust brightness. I

The following lists the ordering number and description for accessory components available to maintain the ScanX to meet your professional needs. Cont

© Copyright Air Techniques, Inc. 2006P/N B8185 Rev. CAir Techniques and ALLPRO Imaging are leading manufacturers of fine dental, medical and veterinar

3CONGRATULATIONSWARRANTYQuickly and easily register your new ScanX on-line. Just have your product model and serial numbers available. Then

SAFETY NOTICE4This equipment has been designed to minimize exposure of personnel to haz-ards. While the ScanX is designed for safe operation, cert

5SAFETY NOTICEUse of Accessory Equipment.The use of ACCESSORY equipment not complying with the equivalent safety requirements of this equipm

6Knowledge of Warnings and Cautions.Users must exercise every precaution to ensure personnel safety, and be familiar with the warnings and cautions pr

7General Notes. All instructions in this manual form an integral part of the unit. They must be kept close to the unit and in readiness whe

8IMPORTANT INFORMATIONCorrect Usage Operation of the ScanX may only be carried out by suitably qualified personnel. The ScanX is only to be used i

9UNPACKING AND INSPECTIONUnpackingThe ScanX is shipped in a special soft pack transport case (P/N B3975) covered by a double-wall corrugated over-pack